Hydac HMG 3000 User Manual download pdf (Page 13)

HMG 3000 Seite 13

Edition 11/2007 - V02 R01-S02 Stock no.: 669712

5 Getting Started Guide

This Getting Started Guide outlines the basic steps for conducting a simple measurement

(measured values shown in display) and recording a measurement curve (graph of measured

values). These examples involve pressure measurement using 2 pressure transmitters with

sensor detection (HSI sensors). For a detailed description of all the settings, see Detailed

Operating Instructions.

The examples are based on the factory settings of the HMG 3000. Simply follow the

steps described here. If you don’t know the status of your HMG 3000 because there

might be more than one user in your company using the HMG, you can simply restore

the unit to its condition as supplied (see Administration Settings — Restore factory

settings).

Preparation in Advance of Performing a Measurement

First charge the batteries or connect the power supply as described in Power Supply. Two

HYDAC HDA 4748-H-0400-000 pressure transmitters with automatic sensor detection are

used in the following example.

Example of a Simple Measurement

Using Two Pressure Transmitters

Integrate the two pressure transmitters

hydraulically in your equipment and connect

the two pressure transmitters using the

sensor connector cables, e.g. to jacks A

and B of the HMG 3000.

After the HMG 3000 is switched on it jumps

to the Current Measured Values menu. The

menu bar (function bar) contains various

functions providing you direct access to the

three main menus:

- Settings - Recording - Extras

and to the display of the Min and Max

values.

Title bar

Function bar

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 75 76

No comments

Hydac HMG 3000 User Manual Page 13